Hydraulic Output Signal - Pentair AUTOTROL MAGNUM 293 Installer Manual

3.6.5

Hydraulic output signal

An optional hydraulic output signal is available on the valve. An optional cam lobe on pilot valve #6
is used on the camshaft assembly to initiate the hydraulic output signal during regeneration or
backwash.
The hydraulic line pressure signal is available through the ¼" connection on the back of the valve
(marked "Aux").
Remove the tube cap installed for shipping. Install one of the available cam lobes.
P/N 1000554
P/N 1000553
P/N 1041064
Ref. MKT-IM-012 / D - 03.02.2022
Provides a hydraulic signal from the beginning of Backwash though the
start of Refill cycle.
Provides a hydraulic signal from the beginning of Backwash through the
end of Refill cycle.
Breakaway cam.
It can be programmed to send a hydraulic signal at any time during the
regeneration or backwash cycle.
The camshaft must be turning for the signal to change states (i.e. switch
from Off to On or vice versa).
Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Description
Optional cam lobe position #6
(Hydraulic output signal)
Auxiliary hydraulic output port "Aux"
25 / 110