Table of Contents
Advertisement
ClimaCon F
Technical description
3.2.2 ClimaCon F 210, F 310
1
Fig. 3:
Design F 210, F 310
1
Control unit
2
Base plate
3
Terminal strip
4
Opening for the cable feed
5
Release clip
3.3
Functional description
The ClimaCon F room thermostats are used to control the
temperature of surface heating and cooling systems as
well as heating and cooling ceilings in detached houses
and multiple dwellings.
The ClimaCon F room thermostats control electrothermal
actuators (e.g. Aktor T 2P) via a cable connection.
Valves are opened or closed via the electrothermal
actuators. If the room temperature is lower than the
setpoint temperature, the valves are opened; if the room
temperature reaches the setpoint temperature, the valves
are closed.
The setpoint temperature is adjusted at the room
thermostat .
All product variants offer the same basic functions.
3.3.1
App connection (F 210, F 310)
The ClimaCon F 210 and F 310 product variants can be
programmed via smartphone app.
Three modes are available for temperature control.
3.3.1.1 Auto mode
In Auto mode, the temperature control follows a time
profile (see par. 7.2.3.2 on page 18).
8
2
3
5
4
3.3.1.2 Eco mode
In Eco mode, the temperature is constantly regulated to
the "Eco setback temperature" (see par. 7.2.3.1 on page
18).
ClimaCon F 210, F 310 devices are equipped with a
setback output (master). Whenever the Eco mode is
active, a voltage is present at this output. The setback
output can be connected to the setback input (slave) of a
ClimaCon F 90, F 100 room thermostat. The voltage at the
setback input reduces the temperature at the slave room
thermostat by 4 Kelvin compared to the temperature set
2
at the scale (position
in Fig. 4 on page 9).
3.3.1.3 Manual mode
You always have the option to set the temperature
manually (see par. 8.2.3 on page 21).
3.3.2 Functions in detail
3.3.2.1 ClimaCon F 90 - Only heating / only cooling
•
Rotary wheel for adjusting the setpoint temperature
•
Frost protection can be activated via rotary wheel
•
Slave input for connection to a master room
thermostat
3.3.2.2 ClimaCon F 100 - Heating or Cooling
•
Rotary wheel for adjusting the setpoint temperature
•
Frost protection can be activated via rotary wheel
•
Slave input for connection to master room thermostat
•
Switching between heating and cooling via change-
over signal
3.3.2.3 ClimaCon F 210 - Only heating / only cooling
•
Dot-Matrix display for visualisation of the setpoint
temperature, the actual temperature, various error
codes, the display "BLu" for the teach-in mode, as well
as the OFF display when the device is switched off
•
LED display heating or cooling
•
LED display with touch surfaces for adjusting the
setpoint temperature via the Plus and Minus keys and
for switching between Auto and Eco mode
•
Control via app (Bluetooth)
•
Possible modes: Auto (daily or weekly schedule), Eco/
Setback, Manual
•
Frost protection (6 °C/ 43 °F) is activated when the
room thermostat is switched off
•
Temperature limitation and offset temperature
adjustable
•
Master output for controlling the setback temperature
of a slave room thermostat
115500983-V02.01.2022
Advertisement
Table of Contents
