Table of Contents
Advertisement
TOOLs reQUired FOr AsseMBLY
(2)
7/16" Wrenches
(2)
1/2" Wrench
(1)
Pliers
(1)
Hammer
sTep 1:
(see FigUre 1)
•
Install a 5/16-18 x 2-3/4" hex bolt (17) and a 5/16"
jam nut (25) in each bag arm channel.
25
17
sTep 2:
(see FigUre 2)
•
Slide the bag arm channels (4) into the sweeper
housing as shown in figure 2. Secure them to the
sweeper housing with a 5/16-18 x 2-1/2" hex bolt (15)
and 5/16" nylock nut (21). Tighten bolt until snug. do
not overtighten.
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
AsseMBLY
4
FigUre 1
15
4
21
FigUre 2
sTep 3:
(see FigUre 3)
•
Secure each bag arm channel to the side of the
sweeper housing with a plastic wing nut (31) installed
onto the bolt assembled in step 1.
•
Insert a pivot rod retainer (30) down into the end of
each bag arm channel.
•
Install a compression spring (32) into the bottom of
each of the pivot rod retainers to secure them to the
bag arm channels.
31
sTep 4:
(see FigUre 4)
•
Attach the drawbar (14) to the sweeper by fastening
a drawbar bracket (8) above and below the drawbar
using three 5/16" x 2-1/2" hex bolts (15) and 5/16"
nylock nuts (21).
14
8
21
30
32
FigUre 3
15
8
FigUre 4
5
Advertisement
Table of Contents
