Page 1
SALES SERVICE CENTER FOR ANY PRODUCT-RELATED QUESTIONS OR CONTACT MSPA AT info@the-mspa.com Due to MSpa continuous product improvement, MSpa reserves the right to change the product appearance and specifications, which may result in updates to the instruction manual without notice.
To guide you in your initial MSpa experience, we are pleased to present you with this instruction manual. Please read this manual carefully before using the product for the first time. We are delighted to welcome you to the MSpa family, and look forward to sharing with you the full spectrum of our expertise.
SAFETY PRECAUTIONS For your own safety and that of your product, please make sure to follow the safety precautions below. Failure to follow the instructions may result in serious injury, property damage or death. Improper installation or operation will void the warranty. PLEASE ENSURE THAT YOU READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS KEEP THIS MANUAL FOR FUTURE REFERENCE DANGER...
Page 4
● Do not use the spa if it is damaged on delivery and/or if it malfunctions in any way. ● Contact the MSpa service center for further instructions. ● Keep all pets away from the spa to avoid any damage.
Page 5
● Do not add bath oil or bath salt to the spa water. ● NEVER PUT HEAD UNDER WATER. ● Avoid swallowing the spa water. CAUTION ● Always add chemicals to water, never add water to chemicals. Adding water to chemicals may cause strong fumes or violent reactions and hazardous chemical spray.
Page 6
Warning: The appliance's water protection levels vary across different product zones, as shown in the following diagram. (The installation regulations comply with IEC 60364-7-702.) 2.5 m Zone 2 Zone 1 Zone 2 2.5 m Zone 0 Zone 0 1.5 m 2.0 m 2.0 m 1.5 m...
REF. NO. PARTS DESCRIPTION QTY. Spa cover with aluminum foil inside (Soho P-SH069 comes with a ground mat with the cover) Spa tub Wired controller Heat preservation bubble mat (For P-CA049/069) Digital lock (except for Soho P-SH069) Inflation hose for bladder...
3. Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground mat. The heat Preservation Mat prevents heat loss from the bottom of the unit. ● NOTE: SOHO P-SH069: Spread out the square ground mat and this side place it to the selected site. Make sure the buckle of cover face down and mat is attached when the spa is not in use.
Page 10
4. Spa Inflation 4.1 Plug the spa into the grounded supply socket. 4.2 Press the RESET button on the PRCD, the screen on controller shows numbers. 4.3 Turn the inflation knob to the inflation status <ON> and long press (≥2 minutes) the bubble button on the controller to start inflating until the yellow section of the manometer is pushed out.
Page 11
WARNING: ● The water level must reach the Minimum water line but not exceed the Maximum line to avoid pump failure. ● Never pour water with a temperature higher than 40°C (104°F) directly into the spa. ● To avoid control system failure, do not operate the spa until water reaches the Minimum line. 6.3 After water filling, double check the spa pool air pressure to make sure the manometer points out to the Green section.
WIRED CONTROLLER OPERATION Heater Button Filter Button Timer Button Bubble Button Down Button Up Button LED display °C °F Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically. NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as approximately 1°C. HEATING HEATER button to turn the heating system on/off.
HEATING TIMER To set the number of hours FROM NOW when the heater will activate: TIMER TIMER button to enter pre-setting mode. The button displays green. 1. Press the 1-99H TIMER 2. Pressing the UP or DOWN button will cause the LED to flash. While it is flashing, you can adjust the number of hours before heater DOWN activation (from 1 to 99 hours).
PARAMETER TEST FREQUENCY CORRECT LEVEL 7.2-7.6 when using Chlorine; Daily 7.2-7.8 when using Bromine Daily 3-5 ppm Free Chlorine Daily 2-4 ppm Bromine residual Weekly 80-120 ppm Total Alkalinity (TA) Weekly 200-500 ppm Total Hardness (TH) NOTE ● A low pH will damage the spa tub and pump. Any damage resulting from a chemical imbalance will void the warranty. ●...
Page 15
Cleaning The Spa Tub If dirt is visible in the water or if the water becomes cloudy and the correct water chemistry does not clear it up, change the water and clean the spa tub. See the “Spa tub drainage” section on how to drain the spa. While empty, clean and/or replace the filter cartridge. Use a sponge and mild soap solution to wipe away any soil or stains on the inside of the spa wall.
PRECAUTIONS FOR SEASONAL USE Inflatable hot tubs are made of reinforced PVC material, whose nature decides the hot tubs are easily affected by weather and temperature. Please do pay special attention when using the spa under different seasonal conditions. In Summer / Sunny days Direct sunshine and hot weather will both lead the spa liner to expand.
SHAPE damage to the spa pool Spa inlet/outlet connection not securely tight Tighten the inlet and outlet connection Close the drainage valve. Contact the MSpa Service Center, if spa Drainage valve is not closed completely SPA LEAKING is still leaking...
● Warranty service outside the country of purchase is limited to the terms and conditions of the corresponding warranty in the country of service. Where the cost of repairs or replacement is not covered by this warranty, MSpa will advise the owners and the cost shall be charged to the owner.
Need help?
Do you have a question about the Soho P-SH069 and is the answer not in the manual?
Questions and answers