Table of Contents
Advertisement
TURNING THE UNIT POWER ON/OFF
1.
When the unit is OFF (STANDBY MODE), tap the POWER
BUTTON (#7) on top of the unit to turn it ON. The last selected input mode icon
will show on LED display.
2.
Tap the POWER
unit OFF and put it in STANDBY MODE.
While setting the Date and Time, the unit may automatically revert back to the time
after 10 seconds if you take too long going through the programming steps. If this
happens, please review the set-up instructions prior to actually programming the
Date and Time.
The LED DISPLAY (#15) will be flashing when the unit is plugged in for the first time.
The unit is now in STANDBY MODE.
SETTING THE DATE AND TIME:
In STANDBY MODE, press and hold the TIME SET BUTTON (#1) until the YEAR
1.
digits show on the display and begin to flash.
Repeatedly tap the DOWN BUTTON
2.
current year. Tap the TIME SET BUTTON (#1) to confirm the year.
3.
The MONTH digits will be flashing on the display.
Repeatedly tap the DOWN BUTTON
4.
current month. Tap the TIME SET BUTTON (#1) to confirm the month.
The DAY digits will be flashing on the display.
5.
6.
Repeatedly tap the DOWN BUTTON
current day of the month. Tap the TIME SET BUTTON (#1) to confirm the day.
"12H" will show on the display.
7.
Tap the DOWN BUTTON
8.
hour clock format (12H) or 24 hour clock format (24H). Default is set to 12 hour
mode. Tap the TIME SET BUTTON (#1) to confirm the time format.
9.
The HOUR digits will begin flashing on the display.
Repeatedly tap the DOWN BUTTON
10.
hour. Make sure the correct AM or PM time is selected when setting the hour. Tap
the TIME SET BUTTON (#1) to confirm the hour.
NOTE: The PM INDICATOR (#22) is located in the upper left part of the display.
The PM INDICATOR (#22) will light when the hour digits selected are for PM time.
The PM INDICATOR (#22) will be off when the hour digits selected are for AM
time.
11.
The MINUTE digits of the clock display begin to flash.
Repeatedly tap the DOWN BUTTON
12.
minutes. Tap the TIME SET BUTTON (#1) to complete the date and time setting.
CHECKING THE DATE AND TIME:
In STANDBY MODE, repeatedly press the TIME SET BUTTON (#1) and the display
will step through the current date and time settings.
1st press – The set Day of the week (d1 – d7): Monday (d1) – Sunday (d7)
2nd press – The set Year
3rd press – The set Month / Date
4th press – The set Time
GETTING STARTED
/ SOURCE BUTTON (#7) on top of the unit again to turn the
SETTING THE DATE AND TIME
(#9) or UP BUTTON
(#9) or UP BUTTON
(#9) or UP BUTTON
(#9) or UP BUTTON
(#10) to select between 12
(#9) or UP BUTTON
(#9) or UP BUTTON
E-9
/ SOURCE
(#10) to select the
(#10) to select the
(#10) to select the
(#10) to set the
(#10) to set the
Advertisement
Table of Contents
