Hitachi RPIL-3.0UFE1NH Service Manual page 14

1 . O P T I O N
1 . O P T I O N
FAN mode
�
button repetitively.
Press Press
Result:
PRESS
Setting temperature
Press
Result: Raise temperature by 1℃.
Press
Lower temperature by 1℃.
Result:
Turning on or off
Press Press button can change the unit operation status.
AUTO, POWERFUL, TIMER and SLEEP operation modes will be specified in the
following pages.
Changing modes during operation, sometimes the unit does not respond at once. Wait for 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be
discharged until temperature of indoor heat exchanger rises.
Wait for 3 minutes before restarting the appliance.
AUTO mode
How to set AUTO mode?
Press the AUTO button.
Result:
What you can do in AUTO mode?
Your feeling
Uncomfortable because
of unsuitable air flow
volume.
Uncomfortable because
of unsuitable flow
direction.
L I S T
L I S T
The fan speed is changed in sequence:
Auto Quiet Low
At "FAN" mode, only "Auto" is not available.
At "DRY" mode, Fan speed is set at "AUTO" automatically, "FAN"
button is ineffective in this case.
button
button
Enters AUTO mode (fuzzy logic operation).
Mode and fan speed are automatically
set based on the actual room temperature.
Press MODE button and cancel AUTO mode.
Note: Temperature, airflow and direction are controlled automatically in AUTO mode.
Button
Low
Medium
High
Range of available set temperature
*HEATING, COOLING, DRY
FAN
*Note: Heating mode is NOT available for cooling only models.
PRESS
Adjust
Indoor fan speed alternates among Auto, Low,Medium
and High each time this button is pressed.
Press it once, the horizontal adjustment louver (vertical
adjustment louver) swings to change vertical airflow
direction (horizontal airflow direction). Press it again,
swings stops.
12
16℃~30℃
unable to set