Chapter 4 Chassis Cable Installation; Chassis Cable Routing And Connection; Best Practices And Recommendations; Ecu Cabinet To Rcm - Sprayer Connections - RCm RG900 Installation Manual

CHAPTE R
4

CHASSIS CABLE ROUTING AND CONNECTION

BEST PRACTICES AND RECOM M ENDATIONS
• Do not connect battery leads until all cables are installed and connected.
• Route chassis cabling along existing cabling or plumbing to help avoid pinch points or stretching the cable
during normal equipment operation.

ECU CABINET TO RCM - SPRAYER CONNECTIONS

1. Locate the single, round connector on the RCM - Sprayer cable (P/ N 115- 2005- 019) provided in the kit.
2. Route this connector to the outside back wall of the ECU Cabinet and connect to the bulkhead connector of the
RCM - Sprayer bulkhead cable installed previously. Align the connector keyways and rotate the locking collar to
secure.
3. Route the RCM - Sprayer cable (P/ N 115- 2005- 019) back along the frame rail towards the RCM - Sprayer
installed previously.
4. Connect the gray and black rectangular plugs to their mating connections of the RCM - Sprayer.
5. Secure the cable with the cable ties provided.
FIGURE 1. Chassis Cable ECU Cabinet Connection
Chassis Cable Installation: Chassis Cable Routing and Connection
C HASSIS CABLE INSTALLATION
C H A P T E R 4
23