Table of Contents
Advertisement
CHAPTE R
3
RCM - SPRAYER INSTALLATION
BEST PRACTICES AND RECOM M ENDATIONS
•
Do not connect battery leads until all cables are installed and connected.
•
If a protected mounting location is not available on the equipment, mount the RCM - Sprayer with the
connectors facing down toward the ground to prevent moisture from accumulating in the RCM - Sprayer
connections.
RCM - SPRAYER M OUNTING LOCATION
1. Locate the foam marker pump (if applicable) and ECU cabinet between the axles on the right side of the
machine.
FIGURE 1. RoGator 1300 ECU Cabinet and Foam M arker Pump Location
N OTE:
If a foam marker is present on the machine, refer to the "RCM - Sprayer M ounting With Foam M arker"
on page 14.
If Raven Autoboom XRT is already installed on this machine, refer to "RCM - Sprayer M ounting with
Raven Autoboom XRT" on page 16.
2. Use the supplied u- bolts (P/ N 107- 0171- 852) and 3/ 8" hardware to secure the RCM - Sprayer mounting plate
(P/ N 107- 0235- 015) to the outside of the frame structure, roughly 12" behind the ECU cabinet. M ount the plate
so that the tabs at the bottom of the plate face toward the center of the machine.
Install the RCM - Sprayer: RCM - Sprayer Installation
I NSTALL THE RCM - SPRAYER
C H A P T E R 3
Foam M arker
M achine ECU
Cabinet
13
Advertisement
Table of Contents
