Table of Contents
Advertisement
CHAPTER 2
INSTALLATION OVERVIEW
The recommended process for installing the RCM - Sprayer product control system is as follows:
1. Confirm RCM - Sprayer kit contents. See the Kit Contents section on page 11.
2. M ount the RCM - Sprayer mounting bracket to the frame and mount the RCM - Sprayer ECU. See the RCM -
Sprayer Installation section on page 13.
3. Install the bulkhead cable in AGCO RoGator C ECU cabinet.
4. Route and connect the chassis and RCM - Sprayer cables. See the Chassis Cable Routing and Connection
section on page 23.
5. Review the Post- Installation Notes for machine configuration tips.
REQUIRED COM PONENTS
The following components must be installed with the RCM - Sprayer nozzle control system:
•
Updated software on field computers or control monitors and other ECUs. Contact your local AGCO dealer for
the latest software.
•
PWM pump control valve
•
Raven compatible flow meter
•
Raven compatible pressure transducer
TOOLS AND M ATERIALS NEEDED
The following tools are recommended for completing the installation:
•
SAE and metric sized wrenches and tools
•
1- 1/ 2" hole saw
•
Drill bit set and drill
•
CorrosionX HD (recommended) or other dielectric contact treatment
•
Cable ties (supplied)
•
Phillips screwdriver
•
Side cutters
POINT OF REFERENCE
The instructions provided in this manual assume the installer is standing behind the machine, looking toward the
machine cabin.
10
RCM - Sprayer Installation M anual for AGCO RoGator C-Series (RG900, RG1100, RG1300)
Advertisement
Table of Contents
