M Achine Configuration Notes - RCm RG900 Installation Manual

CHAPTER 2

M ACHINE CONFIGURATION NOTES

• The AGCO AccuTerminal does not need to have settings changed to function with RCM - Sprayer.
• The AGCO AccuTerminal and other ECUs should be updated to the latest software by an AGCO Service
Provider. For 36 section control, the AGCO RoGator C Liquid EXT software must be updated to version 1.02 or
newer.
• The Raven RCM - Sprayer ECU must be updated to software version of v21.2.1.7 or newer.
• When prompted to setup the machine configuration, complete the following steps:
1. Refer to Table 2 on page 6 and Table 3 on page 7 to find the matching boom/ spacing configuration column to
the physical machine.
2. Input the number of sections of the matching boom/ spacing in the section setup screen as shown in Figure 1,
"Section Setup - Number of Sections," below. There will be 35 or 36 sections based on the "Section" column in
the tables above.
NOTE: It is not necessary to check the fence row option as this functionality is controlled via AGCO switches
and cabling.
FIGURE 1. Section Setup - Number of Sections
3. Press Next to advance.
8 RCM - Sprayer Installation M anual for AGCO RoGator C-Series (RG900, RG1100, RG1300)