RCm RG900 Installation Manual page 19

2. Remove the hardware holding the foam marker mounting bracket and slip the bracket off of the existing u-
bolts.
3. Place the RCM - Sprayer mounting plate (P/ N 107- 0235- 015) on the existing u-bolts with the tabs at the bottom
of the bracket facing toward the center of the machine.
4. Replace the foam marker mounting bracket.
5. Replace the existing nuts to secure the plate and foam marker mounting bracket.
FIGURE 4. RCM - Sprayer M ounted
Install the RCM - Sprayer: RCM - Sprayer Installation
IN STALL THE RCM - SPRAYER
15