Table of Contents
Advertisement
4. For each section, use the color coordination in Table 2 on page 6 or Table 3 on page 7 to select which switch
the section will be mapped to as shown in Figure 2, "Switch M apping - Assigning Sections," below.
N OTE:
Only use numbers 1-5 in the drop- down list for each section according to the color code in the tables.
FIGURE 2. Switch M apping - Assigning Sections
N OTE:
Number of switches may vary from the images shown above.
5. Ensure that the displayed values match the table, and then press Next.
6. For each section, enter the corresponding section width value from Table 2 on page 6 or Table 3 on page 7 as
shown in Figure 3, "Section Setup - Section Widths," below.
FIGURE 3. Section Setup - Section Widths
N OTE:
Number of sections may vary from the images shown above.
7. Ensure the displayed selections are accurate, and then press Next.
Introduction: M ake and M odel Compatibility
IN TRODUCTION
9
Advertisement
Table of Contents
