In Cab Connections - RCm RG900 Installation Manual

FIGURE 12. ECU Cabinet Access for Hawkeye® 2
13. Remove the nut and washer from the round connector of the RCM - Sprayer bulkhead cable.
14. Pass the round connector through the 1- 1/ 2" hole drilled in the rear of the cabinet wall.
15. Reinstall the washer and nut hand tight from behind the ECU cabinet.
16. Replace the AGCO ECU and bracket removed previously using the original hardware.

IN CAB CONNECTIONS

VIPER 4 ISOBUS CONNECTION
1. Connect the two 2-pin Deutsch ISOBUS connectors located behind the Viper
FIGURE 13. ISOBUS Connections
Install the RCM - Sprayer: RCM - Sprayer Installation
Drill 1- 1/ 2" Hole
IN STALL THE RCM - SPRAYER
®
4 together.
21