Sip Phone Attributes - Pgm 211 - LG-Ericsson iPECS eMG80 Programming Manual

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual
4.4.8.7

SIP Phone Attributes - PGM 211

Selecting SIP Phone Attributes will display the SIP Phone input page. Enter a valid SIP Station Number or
range, and click [Load] to view the SIP Phone Attributes for the first Station Number in the range. Enter new
data and click [Save]to modify the attributes for a Station or range.
Registration
For a new registration of SIP station, input ID/PWD & Desired Station Number in PGM 443 of Station User
Login Table. This SIP Phone Attributes are for Stations that are already registered to system.

Register Mode - Register/ Manual: Set Registration Time Out or Not

Registration Status: View connection status (Disconnected or Not) for a station

IP Address: SIP Phone's IP address

IP Port: SIP Phone's IP Port Number

Transport Mode: SIP signaling method

SIP Phone Type: Automatically Assigned by System

Device NAT Usage: Automatic Detection

Registration Timer Usage: OFF – Assign (Re-) Registration Timer by Provisioning (212), ON – Assign
(Re-) Registration Timer by SIP Phone Attributes (211).

Registration Timer: more than 10 minute recommended.

407 Authentication: Authentication of Registration (and Call Setup). To implement authentication, user
login Password should be available in PGM 443 for the Station.
Figure 4.4.8.7-1 SIP Phone Attributes
481
Issue 2.3