Hanil Supra R30 Quick Manual

Quick Guide
Display & Control Panel
LED Display
Status of RPM / RCF / Time /
Setting Time
Temperature / Rotor ID /
Program / ACC / DEC
Up to < 100 hr, Continuous run (00:00)
Program Save / Call Setting Speed
Saving a program Setting RPM
(up to 100) Setting RCF
Calling up a program
Setting Run Parameters
(RPM / RCF / Time / Temperature / ACC / DEC)
Press a parameter Enter the desired valuse
to be changed on the keypad
Setting Rotor ID
Setting Temp. Limit
Temperature range that stops
operation when the temperature
is lower or higher than the set
temperature.
Supra R30
Cat. No. : SU-R30
Setting Temperature
Setting temperature ( -10℃ ~ 40℃)
Setting temp. limit
View Settings Setting ACC / DEC Rate
Verifying the setting ACC (0 ~ 9 steps, Max.9)
parameters during
DEC (0 ~ 9 steps, Natural DEC.0)
centrifugation
Press the
Enter button Save or call button
After loading the rotor,
press the Rotor button
Press the
Temp. limit button
Serial No.
Setting Rotor ID.
Lid Open
Start Stop
Pulse
After reaching the set speed,
the centrifugation is decelated
and stopped
Saving / Calling Up a Program
Press the Enter the desired program
number on the keypad
Enter the rotor ID
on the keypad
Enter the desired temperature
range on the keypad
Installation Date
Max. RPM : 30,000 rpm
Max. RCF : 106,657 xg
Key Lock Power Switch
Press the
Enter button
Press the
Enter button
Press the
Enter button