Connecting Projector; Terminals Of Projector - Christie 38-VIV402-01 User Manual

CONNECTING PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from
computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just
by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.
REPLACEMENT OF TERMINAL
NOTE; When replacement of terminal board, MAIN
ON/OFF switch should be OFF position.
1 Remove 2 Screws on terminal.
2 Pull out terminal by holding handle.
3 Replace terminal. Insert terminal along Guide to fit Plug
into Socket.
4 Tighten screws to secure terminal.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board
(Terminal Board), contact your sales dealer. When con-
tacting the sales dealer, tell the Optional Control
Number (Op.cont.No.) in the menu that is located under
Language Select Menu. (See page 40.)

TERMINALS OF PROJECTOR

SERIAL PORT IN
SERIAL PORT OUT
R/C JACK
INPUT/OUTPUT
AUDIO OUT
TERMINALS
4 TERMINAL SLOTS (Factory set)
DVI
R/Pr G/Y B/Pb H/HV V
USB S-VIDEO
VIDEO/Y C
ANALOG RGB
R L
RESET
(MONO)
Figure shows HDB 15-PIN terminal.
Plug
AUDIO
CONTROL PORT
R L DVI Terminal
(MONO)
AUDIO CONTROL PORT
R L
5 BNC Terminal
(MONO)
AUDIO
R
L
AV Terminal
(MONO)
AUDIO CONTROL PORT
HDB 15-PIN
R
L
Terminal
(MONO)
Screws
Guide
Socket
11