Connecting Projector; Terminals Of Projector - Christie 38-VIV210-01 User Manual

CONNECTING PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from
computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just
by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.
REPLACEMENT OF TERMINAL
NOTE; When replacement of terminal board, MAIN
ON/OFF switch should be OFF position.
1 Remove 2 Screws on terminal.
2 Pull out terminal by holding handle.
3 Replace terminal. Insert terminal along Guide to fit Plug
into Socket.
4 Tighten screws to secure terminal.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board
(Terminal Board), contact your sales dealer. When con-
tacting the sales dealer, tell the Optional Control
Number (Op.cont.No.) in the menu that is located under
Language Select Menu. (See page 33.)

TERMINALS OF PROJECTOR

INPUT/OUTPUT
TERMINALS
TERMINAL SLOT (Factory set)
AUDIO
CONTROL PORT
ANALOG RGB
R L
(MONO)
L
AUDIO OUT
SERIAL PORT OUT
SERIAL PORT IN
R L
R/C JACK
RESET (MONO)
Plug
Figure shows HDB 15-PIN terminal (Optional parts).
HDB 15-PIN Terminal
USB
Screws
Guide
Socket
11