Table of Contents
Advertisement
CONNECTING PROJECTOR
HDB 15-PIN INPUT TERMINAL
Connect computer output
(Analog HDB 15-pin type) to
this terminal.
(Refer to P13.)
SERIAL PORT
IN TERMINAL
If you control a projector by computer,
you must connect a cable (not
provided) from your computer to this
terminal.
RESET BUTTON
This projector uses a micro processor
to control a unit. Occasionally, this
micro processor may malfunction and
need to be reset. This can be done
by pressing RESET button with a
pen, which will shut down and restart
unit. Do not use RESET function
excessively.
SERIAL PORT
OUT TERMINAL
This terminal outputs signal from
SERIAL PORT IN. More than two
projectors can be controlled with one
computer by connecting SERIAL
PORT IN. of another projector to this
terminal.
12
INPUT/OUTPUT TERMINALS AND JACKS
AUDIO INPUT JACKS
Connect an audio output
from computer to these
jacks. (Refer to P13.)
SERIAL PORT IN
R/C JACK
RESET
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.
(Refer to P13.)
CONTROL PORT CONNECTOR
This port is used to service
this projector.
AUDIO
CONTROL PORT
ANALOG RGB
R
L
(MONO)
L
AUDIO OUT
SERIAL PORT OUT
R
L
(MONO)
USB PORT (Series B)
This port is used to service
this portt.
USB
Advertisement
Table of Contents
