The Handy THS80 Operator's Manual And Parts List page 9

STEP 6: AD JUSTMENTS. W hen you have finished all above steps, and if you find the three
big ho les at th e bottom of hopper just m at c h the t hree ho les of adjustable plate. You don't
need to d o the fo llowing steps . If t hey do not matc h neatly, you may need to do the
f oll ow ing s teps . (1)Release two bolts M5 x10 on clamp as shown . (2) . Push the handle to the
low est position <downwards>, use your ha nd to adjust the adjustab le plate so as to ma ke sure
three big holes at the bottom of hopper just mat ch the th rees hole s of adju stab le plate neatly. (3) .
A nd then tighte n the bolts and nuts on clamp again .
To operate th is spreader, push the hand le to th e t o p pos itio n (upwards). You may move
t he po sitio n of W in g nut on Gaug e & Lever t o adj ust the spacer on the three holes
bet w een the hopper and t he adj us tab le pl at e as per yo ur req uirements when spreading.
rVl ov e the po sition of th is nut co uld adju st
t il e spacer of th ree hol es betwe en hopper
and adju stab le p late as per your need
2 . Push the ha nd le to the lowes t when spread ing . .
pos itio n-cdownw ard s>, use you r hand to
a djust th e ad justable plate so as to make
sur e th ree big hole s at the bottom of
ho pp er just m atc h t he threes ho les of
adjusta ble plate nea tly.
I
To op erate th is spread er. pus h
til e handle to the top po sition.
1.Re lease these
two bo lts.
3.Tighte n these
two bolts
aga in.
Irnpeller must be tu rning
in this direction when
push forward.