The Handy THS80 Operator's Manual And Parts List page 10

Before filling the hopper, become familiar with the operation of this spreader.
•
Check the proper setting for the material to be used in the RATE SETTING CHART
included with this spreader.
•
Move the stop bolt on the rate gauge assembly to the proper setting.
•
While pushing the spreader forward, pull the control lever back to the stop bolt.
•
Before you stop moving, push the lever forwards to close the flow holes.
•
When finished, empty any remaining material from the hopper.
•
Thoroughly wash the spreader and allow it to dry before storing. No oiling is necessary.
•
Remove the agitator when using Rock Salt to prevent gearbox damage.
OPERATING INSTRUCTIONS