The Handy THS80 Operator's Manual And Parts List page 3

1. HELPFUL HINTS:
READ THE DIRECTIONS BEFORE ASSEMBLY
WHEN ALL ELSE FAILS, READ THE DIRECTIONS AGAIN
• If your spreader does not spread evenly, be sure the FRONT on the gear box points to
the front of the spreader. The impeller must turn clockwise. Reversing the gear box will
cause the impeller to turn counter clockwise. Clean the impeller plate after each use.
Fertilizer stuck on the impeller blades will cause uneven spreading.
• Your spreader is designed to be pushed at three miles per hour, which is a brisk walking
speed. Slower or faster speeds will change the spread patterns. Wet fertilizer will also
change the spread pattern and flow rate. Clean your spreader thoroughly after each
use. Wash between the shut off plate and bottom of the hopper.
• Gears are permanently lubricated at the factory. Do not open the gear box or dirt may
enter.
2. Remove and identify loose parts from carton and bag.
Bolt 1'v16x65
4PCS
Bolt 1'v16x40
6F'CS
Bolt
1'v1~)x4~)
1PC
Round Head
Bolt 1'v14x20
1PC
Lock Nut 1'v16
SPCS
Flat Washer06
4PCS
Lock Nut MS
1PC
Big Flat
W2.sher 016
1PC
Axle End
Cover 2PCS
Inner" Axle
Bushing
2PCS
R Pin
1PC
Impeller
1PC
Fixing Roe!
1PC
Wheel
Assembly
Frame
2PCS (1PAIR)
Tire 2PCS
Handle Assembly
1PC
Support LeeJ
1PC
C;C1r Box & ;\xle
lPC
Hopper
1PC