Aerosol-tight rotors
When using an aerosol tight lid the rotor can be removed with the lid closed. This is to protect you and
the samples.
Audible alarm
Error
Accompanying all error messages, a warning signal is given out.
Press any key to silence the warning signal.
End of run
By default there is an acoustic signal at the end of any centrifugation run. To switch off this signal
proceed as follows:
Press the
The display shows:
or
4. Press the
The acoustic signal is turned on or off.
5. Press the
Turning off the centrifuge
1. To turn off the centrifuge put the mains switch to "0".
Note The centrifuge is equipped with a special switch for balancing potential voltage discrepancies
key when you turn on the centrifuge.
key under the display in the middle.
key to confirm the pre-selected value.
in the power grid. After pressing the mains switch the display therefore may still flash up to
10 seconds.
4
Introduction and description
Aerosol-tight rotors
VWR MICRO STAR 17 / 17R
4-9