Download Print this page

WATSON BAHN Assembly Instructions

Hide thumbs Also See for BAHN:

Download this manual

BA H N

LO CKER AS S E M BLY I NST R UC TI O N S

V.1.0 10/15

INS-BNLOCKER

Page 1 BA H N LO CKER AS S E M BLY I NST R UC TI O N S V.1.0 10/15 INS-BNLOCKER...
Page 2: Tool Tips
LOCKER COMPONENTS One Door Locker Two Door Locker Three Door Locker Four Door Locker Anti-Tip Kit Two Door Cubby Four Door Cubby Six Door Cubby Eight Door Cubby FASTENERS ¼-20x1” FM Bolt (490710) ¼-20 Barrel Nut (490713) #8-¼x1¼” Phillips Pan Head #10-¾”...
Page 3 S id e to Si de G an gi ng Drill 5/16” holes through the side walls at 7/64 pilot locations. Only partially drill through the side to prevent chipping. Connect the units with ¼-20x1”FM bolts (x4) and ¼-20 Barrel Nuts (x4). Bahn Locker Assembly INS-BNLOCKER...
Page 4 S e cure to Fr ees t an di ng Ra c eway Drill 2 each 3/16” clearance holes through the Raceway End Panel. Secure the Locker to the Raceway with #8 x 1¼” screws (x2). Bahn Locker Assembly INS-BNLOCKER...
Page 5 Slide the cabinet toward the wall leaving enough room to attach the strap to the D-rings. Attach the strap and slide the cabinet as close to the wall as it will go. Note — Reference INS50008. Bahn Locker Assembly INS-BNLOCKER...