Assembly - Husqvarna 330LK Operator's Manual

Grass trimmer head
• Make sure that you wind the grass trimmer line
tightly and equally around the drum to decrease
the vibration.
• Use only the approved grass trimmer heads and
grass trimmer lines. Refer to
page 14 .
• Use a correct length of the grass trimmer line. A
long grass trimmer line uses more engine power
than a short grass trimmer line.
• Make sure that the cutter on the cutting
attachment guard is not damaged.
• Soak the grass trimmer line in water for 2 days
before you attach the grass trimmer line to the
product. This increases the life of the grass
trimmer line.
• Refer to the instructions for the cutting
attachment to use the correct procedure to load
the cord and the correct cord diameter.
Fuel Safety
WARNING:
instructions that follow before you use
the product.
• Never start the product if you spill fuel on it. Wipe
the spillage of and allow remaining fuel to
evaporate.
• Never start the product if you spill fuel on
yourself or your clothes. Change your clothes
and wash any part of your body that has come in
contact with fuel. Use soap and water.
• Never start the product if the product is leaking
fuel. Check regularly for leaks from the fuel cap
and fuel lines.
• Always put the product on a flat surface and
make sure the cutting attachment cannot come in
contact with any object while you add fuel.
• Take care when handling fuel. Bear in mind the
risk off fire, explosion and inhaling fumes.
• Observe caution when handling fuel and make
sure there is adequate ventilation. Fuel and fuel
fumes are highly inflammable and can cause
serious injury when inhaled or allowed to come in
contact with the skin.
• Mix and pour fuel outdoors, where there are no
sparks or flames.
Introduction
WARNING:
the product, you must read and
understand the safety chapter.
1660 - 003 - 29.09.2021
To trim the grass on
Read the warning

Assembly

Before you assemble
• Do not smoke or place hot objects near fuel.
• Always stop the engine and let it cool off for a
few minutes before you refuel.
• Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
• Tighten the fuel cap carefully after you refueled.
• Clean the area around the fuel cap.
Contamination in the tank can cause operating
problems.
• Always move the product 3m (10ft) or further
from the refuelling area and source before
starting.
Safety instructions for maintenance
WARNING:
instructions that follow before you use
the product.
• Stop the engine, make sure that the cutting
attachment stops and let the product cool down
before you do the maintenance.
• Disconnect the spark plug cap before you do the
maintenance.
• The exhaust fumes from the engine contain
carbon monoxide, an odorless, poisonous and
very dangerous gas that can cause death. Do not
run the product indoors or in closed spaces.
• The exhaust fumes from the engine are hot and
can contain sparks. Do not run the product
indoors or near flammable material.
• Accessories and changes to the product that are
not approved by the manufacturer, can cause
serious injury or death. Do not change the
product. Always use original accessories.
• If the maintenance is not done correctly and
regularly, there is an increased risk of injury and
damage to the product.
• Only do the maintenance as this operator's
manual recommends. Let an approved
Husqvarna service agent do all other servicing.
• Let an approved Husqvarna service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
WARNING:
cable from the spark plug before you
assemble the product.
Read the warning
Remove the spark plug
9