Husqvarna 330LK Operator's Manual page 10

To assemble the loop handle
1. Attach the loop handle onto the shaft between
the arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the bolt. Do not
tighten the bolt fully.
4. Adjust the product to a correct position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with
the arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until
you hear a click.
10
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the engine
4. Pull the attachment straight out of the coupling.
A
To install the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A)
2. Put the cutting attachment guard onto the fitting
coupling.
is attached to.
C
for the trimmer head. Refer to
page 22 .
on the shaft.
Accessories on
1660 - 003 - 29.09.2021