Husqvarna 330LK Operator's Manual page 13

• Make sure that all covers, the cutting attachment
guard and the trimmer head are correctly
attached and not damaged. Replace damaged
parts.
To start a cold engine
1. Push the air purge bulb 10 times.
2. Put the choke control in the full choke position.
1660 - 003 - 29.09.2021
3. Hold the product on the ground with your hand.
Do not step on the product.
WARNING:
throttle trigger while you start the
engine.
4. Pull the starter rope handle 3 times slowly and
carefully without too much force.
CAUTION:
starter rope until it stops. Do not let
go of the starter rope when it is fully
extended. Release the starter rope
slowly. Failure to obey these
instructions can cause damage to the
engine.
5. Push the choke control down to the half choke
position in the center.
6. Pull the starter rope handle until the engine
starts.
Note:
If the engine does not start, do the start
procedure from step 1.
7. Let the engine run for 10 seconds.
Do not pull the
Do not pull the
13