Husqvarna 330LK Operator's Manual page 12

CAUTION:
stroke oil for water-cooled outboard
engines, also referred to as outboard
oil. Do not use oil for four-stroke
engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION:
influence the ratio of the mixture
drastically when you mix small quantities
of fuel. Measure the quantity of oil
carefully and make sure that you get the
correct mixture.
1. Fill half the quantity of gasoline in a clean
container for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
12
Do not use two-
Two-stroke
oil, liter
2% (50:1)
0.10
0.20
0.30
0.40
US fl. oz.
2 ½
6 ½
12 ⅞
Small errors can
Do not mix fuel for more
To fill the fuel tank
WARNING:
that follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel
is fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
is not too much fuel in the fuel tank.
The fuel expands when it becomes
hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from
the refueling area and fuel source before you
start the engine.
Note:
To see where the fuel tank is on your
Introduction on page 2 .
product, refer to
To do before you operate the
product
WARNING:
without a guard or a guard that is
defective.
• Examine the work area to make sure that you
know the type of terrain. Examine the slope of
the ground and if there are obstacles such as
stones, branches and ditches.
• Do an inspection of the product.
• Do the safety inspections, maintenance and
service that are given in this manual.
Obey the procedure
Make sure that there
Do not use the product
1660 - 003 - 29.09.2021