Table of Contents
Advertisement
H15U
13) Run the wires through the grommet.
14) Connect black & red wires ( both 90 degrees)
to thermodisc and secure wires with wire
holder.
Black Wire at the bottom
920-474
Hampton® H15U-NG/LP Direct Vent Freestanding Gas Stove
15) Connect the remaining wires.
Live wire from fan (black) to 704 (black)
704 (red) to 501(red)
Secure all the wires using wire holder on the
rear panel.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.
16) Slide the Rear Access Panel back into
position and secure with 2 screws.
Rear Panel
installation
Finalized Installation
11.24.21
15
Advertisement
Table of Contents
