Paring Addresses - Panasonic CZ-RWS3 Operating Instructions Manual

Paring Addresses

When more than 1 indoor units are installed in the same room with a
compatible remote controller, addresses can be set up to avoid crosstalk.
You can control up to 6 indoor units individually by the supported remote
controller by pairing the address on the remote controller and the number on
the address switch on the receiver.
There are separate address settings: receiver addresses for the receivers,
and transmitter addresses for the remote controller.
Units will not be controlled if the setting do not match.
Checking Addresses
1. Press
ADR
unfolded paper clip (or a
similar object that can fit).
• Its current address appears on
the display for 5 seconds.
• If this address corresponds to the
address of a receiver, the buzzer
sounds. (If it is on ALL, the
buzzer will always sound.)
• If it is on ALL, it can be operated
regardless of receiver addresses.
Point the remote controller at the
receiver you wish to operate and transmit.
Matching Up Addresses
■
If not wall mounted type indoor
unit
< Setting Remote Controller
Addresses >
1. Press
ADR
unfolded paper clip (or a
similar object that can fit) for
4 seconds or longer.
• The current address number
starts blinking.
16
(EN)
RC
with one end of an
RC
with one end of an
1
Address
Address
2
1, 2