Installing Batteries - Panasonic CZ-RWS3 Operating Instructions Manual

Names and Operations (Cont.)
Emergency operation
Use [Emergency Operation]
urgent need.
• When the remote controller's batteries have failed.
• When the remote controller is broken.
• When the remote controller is lost.
1. Press [Emergency Operation]
• The OPERATION lamp is lit.
• Auto operation starts. If Auto operation is not possible, the unit starts
cooling if the room temperature at the time is 24 °C or higher; otherwise,
the unit starts heating.
• The operation stops if you press [Emergency Operation]
Note
• If non-cooling/heating free type is being used, it will beep twice and the operating
lamp will light up on the display; if the timer and standby lamps blink alternately, a
conflict between the heating and cooling exists, so the unit cannot operate in the
desired mode. (On models that do not have an Auto function, even if Auto is
selected, it works in the same way.)
• When the local operation is disabled by a central control device or similar cause,
and if the Start/Stop
/
will beep 5 times and the change will not be made.

Installing Batteries

1. Remove the battery cover.
• Pinch the handle and open while pressing it
towards the ▼ mark.
12
(EN)
, Fan speed
, Mode select
in the following situations when there is an
of the receiver.
, Flap
or Energy saving
again.
, Temperature setting
button is pressed, the unit
Handle
Battery cover