Addresses - Panasonic CZ-RWSU1U Operating Instructions Manual

Wireless remote control system
Table of Contents

Advertisement

11. ADDRESSES

In both multi and single unit installations, when more than one indoor unit is installed in the same
room with a compatible remote controller, addresses can be set up to avoid crosstalk.
By setting the address switches on the receivers and matching them with the number of addresses on
the remote controller, up to six indoor units can be controlled separately with the remote controller.
(When using units in a fl exible combination or operating multiple units simultaneously, as they are
operated at the same time, they cannot be controlled individually.)
There are separate address settings, receiver addresses for the receivers*
for the remote controller.
For more information, please contact the dealer where the product was purchased.
• The setting procedure is different for CZ-RWSY1U and Indoor Unit (CZ-RWSK1U). (See Page 18)
• These settings are saved in nonvolatile memory in the remote controller, so even when its batteries
are changed, the settings do not have to be made again.
*
CZ-RWST1U is of receivers (Inside the indoor unit); CZ-RWSU2U is of an operation panel. (Inside
1
the indoor unit)
Checking Addresses
When you press
on the remote controller, its current address is shown in the display. If this
address corresponds to the address of a receiver*
always sound.)
If it is on ALL, it can be operated regardless of receiver addresses. Point the remote controller at the
receiver you wish to operate and transmit.
*
CZ-RWSU2U is a receiver (Indoor unit)
2
Matching up Addresses
Setting Remote Control Addresses
1. If you press
and
2. While holding
down, every time you press
6 ALL.
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
, the buzzer sounds. (If it is on ALL, the buzzer will
2
at the same time, "
, the address that was displayed is set.
16
and transmitter addresses
1
" will blink.
, it cycles from ALL 1 2 3...

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cz-rwst1uCz-rwsc1uCz-rwsu2uCz-rwsy1uCz-rwsk1u

Table of Contents