RC
2. Press
to select the address of the receiver you want to
ADR
control, and press
• Every time you press
1 → 2 → 3 → 4 → 5 → 6".
• If it corresponds to the receiver's address setting, the buzzer sounds.
Note
• Set the address of the receiver as instructed in the operating instructions of your
receiver. Do not set by yourself. Contact the dealer where the product was
purchased.
■
For wall mounted type indoor unit
< Setting the address of the indoor unit >
1. Press [Emergency Operation]
4 seconds or longer.
• OPERATION lamp, TIMER lamp, and then STANDBY lamp repeatedly
light one after the other for 1 second each to indicate the unit is ready for
address setting.
< Setting Remote Controller Addresses >
2. Set the address for the remote controller following the
procedure under the section "■ If not wall mounted type indoor
unit" (see page 16).
• Repeat Step 2 under "■ If not wall mounted type indoor unit" if you are
setting more units.
• The address setting ready status of the indoor unit ends if data
transmission is not received from the remote controller for 3 minutes.
• Press [Emergency Operation]
setting ready status of the indoor unit.
.
RC
, it cycles from "ALL (All the addresses) →
ADR
of the indoor unit for
on the receiver to end the address
17
(EN)