Panasonic CZ-RWS3 Operating Instructions Manual page 9

1 remote controller can control a group of up to 8 indoor units.
(See page 28)
1. Operation Display
Displays the operation status.
(The figure shows all the
statuses.)
2. Start/Stop button
Pressing this button once starts
and pressing again stops the
operation.
3. Fan speed button
Press to change the fan speed.
4. Flap button
Press to change the flap direction.
5. ECONAVI button
Press to set ECONAVI.
6. nanoe™ X button
Press to set nanoe™ X.
7. Ventilation button
Use this when connected to an
aftermarket fan.
8. Clock button
Use this to set the clock.
9. Cover
Press at the top center and then
slide down.
10. Transmitter
ECONAVI
nanoeX
11. Temperature setting buttons
raises the temperature
setting 1 °C at a time.
lowers the temperature
setting 1 °C at a time.
12. Mode select button
Press to switch the operation
mode.
13. Energy saving button
Press to enable or disable energy
saving.
14. Filter button
Press to turn off the filter lamp on
the receiver.
15. Timer setting buttons
/ /
Use for operating with a timer.
16. RC reset button
Use this button after changing the
batteries.
17. RC address button
Press to set addresses.
From this page, the names of
remote controller's buttons will be
indicated with the above
illustrations.
E.g.: Start/Stop button 
/ / /
RC
RESET
RC
ADR
(EN)
9