Ventilation Setting; Energy Saving Setting - Panasonic CZ-RWS3 Operating Instructions Manual

Ventilation Setting

(When connected to an aftermarket fan)
button is disabled as the factory setting. Enable the
have connected the ventilation fan. (See page 30)
1. Press .
• You can toggle between ON and
OFF each time you press
• " " appears on the display of
the remote controller when the
fan is operating.
• When the air conditioner is
started or stopped, the fan starts
or stops at the same time.
• " " is displayed if the function
is not available.

Energy Saving Setting

1. Press during operation.
• You can toggle between ON and
OFF each time you press
• " " is displayed when this
setting is ON.
• The energy saving operation
restricts the maximum current
value, resulting in decreased
cooling/heating performance. (If
the current of outdoor units does
not reach the peak due to low
load operation, the current value is not restricted.)
• If the receiver emits 1 short beep followed by 1 long beep after pressing
, the indoor unit does not support this function. See page 30 for
how to enable or disable the button.
• " " is displayed if the function is not available.
.
1
.
1
button if you
23
(EN)