Download Print this page
RKI Instruments 65-2437RK-05 Operator's Manual

RKI Instruments 65-2437RK-05 Operator's Manual

Carbon monoxide detector

Advertisement

Quick Links

Part Number: 71-0190RK
Revision: C
Released: 7/7/20
1.800.561.8187
information@itm.com
www.
.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the 65-2437RK-05 and is the answer not in the manual?

Questions and answers

Summary of Contents for RKI Instruments 65-2437RK-05

  • Page 1 Part Number: 71-0190RK Revision: C Released: 7/7/20 1.800.561.8187 information@itm.com www. .com...
  • Page 2 WARNING 1.800.561.8187 information@itm.com www. .com...
  • Page 3 OBLIGATIONS OR LIABILITIES ON THE PART OF RKI INSTRUMENTS, INC. INCLUDING BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL RKI INSTRUMENTS, INC. BE LIABLE FOR INDIRECT, INCIDENTAL, OR CONSEQUENTIAL LOSS OR DAMAGE OF ANY KIND CONNECTED WITH THE USE OF ITS PRODUCTS OR FAILURE OF ITS PRODUCTS TO FUNCTION OR OPERATE PROPERLY.
  • Page 4 1.800.561.8187 information@itm.com www. .com...
  • Page 5 WARNING: Do not use this product in a manner not specified in this instruction manual. WARNING: When using the 65-2437RK-05, you must follow the instructions and warnings in this manual to assure proper and safe operation of the 65-2437RK-05 and to minimize the risk of personal injury. Be sure to maintain and periodically calibrate the 65-2437RK-05 as described in this manual.
  • Page 6 Terminal Block Rubber Spacer, Black J-Box CO Detector 1.800.561.8187 information@itm.com www. .com...
  • Page 7 Detector Housing Body Cap Gasket Plug-In CO Sensor Rubber Boot With Charcoal Filter Detector Housing Cap Flame Arrestor Guard Detector Housing, Housing Cap, & Cap Gasket Plug-In Sensor Charcoal Filter 1.800.561.8187 information@itm.com www. .com...
  • Page 8 1.800.561.8187 information@itm.com www. .com...
  • Page 9 3.10 3/4 NPT Female 3.65 8.45 MA X Rubber Spacers J-Box CO Detector 1-1/2 - 20 Thread for Calibration C up 1.800.561.8187 information@itm.com www. .com...
  • Page 10 WARNING: If the controller’s construction is not explosion-proof, the controller must be installed in an ordinary location. Do non install a non-explosion-proof controller in a classified location. WARNING: To maintain the explosion proof classification of the CO detector, a conduit seal must be used within 2 inches of the junction box conduit hub used for wiring to the controller.
  • Page 11 Cable Shield Install conduit seal Controller Detector/Transmitter within 2 i nches Terminals, Typical D esignations Controller H ousing (installed in ordinary location if device is non-explosion-proof) Terminal Block Black CO Detector 1.800.561.8187 information@itm.com www. .com...
  • Page 12 CAUTION: Allow the detector to warm up for 5 minutes before you continue with the next section, “Setting the Zero (Fresh Air) Reading”. WARNING: If the detector installation is explosion proof, do not remove the detector housing cap or junction box cover while the circuits are energized unless the area is determined to be non-hazardous.
  • Page 13 Daily Quarterly 1.800.561.8187 information@itm.com www. .com...
  • Page 14 Note: Under “normal” circumstances, the detector requires calibration once every 3 months. Some applications may require a more frequent calibration schedule. Replacing the Plug-In CO Sensor CAUTION: The sensor contains electrolyte which is a dilute acid. Do not disassemble the sensor when replacing it with a new one.
  • Page 15 WARNING: The sensor will not operate properly if the wire jumper is not removed. Remove jumper CAUTION: Allow the replacement sensor to warm up for 5 minutes before you continue with the next step. Replacing the Charcoal Filter 1.800.561.8187 information@itm.com www.
  • Page 16 Replacing the CO Detector CAUTION: Allow the replacement detector to warm up for 5 minutes before you continue with the next step. 1.800.561.8187 information@itm.com www. .com...
  • Page 17 WARNING: Do not remove the detector housing cap while the circuits are energized unless the area is determined to be non-hazardous. Keep the detector housing cap tightly closed during operation. 1.800.561.8187 information@itm.com www. .com...
  • Page 18 1.800.561.8187 information@itm.com www. .com...
  • Page 19 65-2437RK-05 CO Detector Operator’s Manual 1.800.561.8187 information@itm.com www. .com...