7. CLEANING AND MAINTENANCE
1. Turn off and unplug the device to avoid acci-
dents while cleaning.
2. Clean the inside of the device using a damp
cloth with a non-corrosive product.
3. Do not scrub the inside of the device with metal
scrapers. It will damage the coating.
8. TROUBLESHOOTING
problem
the light does not
turn on
the device does not
heat up
too high or too low
temperature
EN
9. DISPOSAL
The crossed bin symbol on the appliance indicates
that the product, at the end of its life span, must be
disposed of separately from domestic waste, either
by being taken to a separate waste disposal site for
electric and electronic appliances or by being re-
turned to the dealer when buying another similar
appliance. The user is responsible for taking the
appliance to a special waste disposal site at the end
of its life span. Failure to do so may be sanctioned
with penalties under the waste disposal regulations
12
causes
the device is not connected to power
source
1. loose cable in the heater
2. heater is burnt
3. electrical components are damaged
thermostat out of adjustment
4. Do not clean the device with direct water jets.
This damage the electric components of the
machine.
5. If the device is not going to be used for a longer
period, turn off the power and unplug the device.
possible remedies
1. tighten the screw fixing the cables
2. replace the light bulb
1. tighten the screws from which
the cables are fed
2. replace the heater
3. replace electrical components
replace thermostat
in force. If the disused appliance is collected correctly
as separate waste, it can be recycled, treated and
disposed ecologically; this prevents negative impact
on both the environment and the health. For further
information regarding the waste disposal services
available, contact your local waste disposal agency
or the shop where you bought the appliance. The
manufactures and importers do not take the re-
sponsibility for recycling, treatment and ecological
disposal, either directly or through a public system.
Need help?
Do you have a question about the 230404 and is the answer not in the manual?