Getting Started; Battery Backup; Radio Operation; Alarm Function - Hyundai RAC 521 PLLBCH Instruction Manual

GETTING STARTED

Plug the DC adaptor inlet into the dc 5V jack (11). When electrical power has been interrupted and
restored, if there are 2 AAA batteries in the radio and the power off and on again, the clock display
will show the time. Make sure to reset both the correct time and alarm time for proper operation.
TIME SETTING
Press and hold the TIME SET/M+ (5), then the clock display will blink. press the HOUR/TU- (2) or
MIN/TU+ (3) to set the clock display to the correct time. Press TIME SET/M+ (5) again when finished
the setting, the time display will not blink.
DIMMER HIGH/LOW/OFF
On time display mode, long press HIGH/LOW/OFF (4) to set high or low of the LED display or turn off
the LED display.

BATTERY BACKUP

This clock has a backup power system to ensure continuous operation during power failure. Insert
two AAA batteries into battery compartment and the clock mechanism will continue to maintain the
current time. Batteries provide no function other than the backup time. It does not allow you to listen
to radio, sound an alarm or to display the time.

RADIO OPERATION

Long press POWER/FUN (1) to turn on the radio.
• Short press POWER/ FUN (1) to select AM band or FM band or AUX.
• Press HOUR / TU-(2) or MIN/TU+ (3) to adjust your desired frequency.
• Press AL 2/VOL + (7) to increase the volume, the maximum level up to level 16,
the default volume is 12.
• Press AL 1/VOL- (6) to decrease the volume, the minimum level of volume is level 0.
MEMORY OPERATION
The clock radio can store 20 AM and 20 FM presets.
• On radio playing mode, select your desired band (FM/AM), press MIN/TU+ (3) or HOUR / TU- (2)
to choose your desired frequency.
• Press and hold TIME SET/M+ (5) to enter into preset mode, the preset number will show and flash
on the led display.
• Then short press HOUR/TU- (2) or MIN/TU+ (3) to select your desired memory numbers from P1
to P20.
• Press the TIME SET/M+ (2) to confirm your memory setting.
• Repeat the above steps, you can store your desired stations.
When the setting is correct, press TIME SET/M+ (5) to select your preset frequency to enjoy radio.
Press POWER /FUN (1) to turn off the radio.

ALARM FUNCTION

SETTING ALARM 1 / ALARM 2 BY BUZZER
In clock display mode, press AL 1/VOL- button (6) / AL 2/VOL+ button (7) once to select alarm by
buzzer. The AL1 Buzzer / AL1 Buzzer icon and alarm time display will flash. Using HOUR/TU- button
(2) and MIN/TU+ button (3) to set your desired alarm hour.
SETTING ALARM 1 / ALARM 2 BY RADIO
In clock display mode, press AL 1/VOL- button (6) / AL 2/VOL+ button (7) twice to select alarm by
radio. The AL1 RAD / AL2 RAD icon and alarm time display will flash. Using HOUR/TU- button (2)
and MIN/TU+ button (3) to set your desired alarm hour.
EN - 14