Printing Operation; Restrictions During X-Y Printing; Exception (Error) - A&D Omniace III RA2300A Instruction Manual

12. X-Y Recorder

12.3. Printing Operation

Pressing the Start button on the operation panel clears X-Y data display from the X-Y monitor and,
shortly after that, re-displays the X-Y data display again. Pressing the Stop button stops the X-Y
monitor and prints the X-Y waveforms on chart paper. If the file saving is set to be valid during this
period, recording data can be saved in a file.
Pressing the Stop buttons two times cancels the output to chart paper. Avoid pressing the
button more than two times.
NOTE

12.3.1. Restrictions during X-Y Printing

There are following restrictions in X-Y printing.
● Setup changes cannot be made.
● X-Y monitor clear and stop cannot be made.
● Screen movement cannot be made.
Press the STOP button and finish the X-Y printing to execute the operations above.

12.3.2. Exception (Error)

An error may be generated during X-Y printing due to the following reasons.
● Paper-out
This error is generated when the chart paper is run out. Fill in a chart recording paper.
After X-Y printing, the monitor stops display temporarily. After filling a chart recording
NOTE
paper, pressing the Print icon button performs the display same as the X-Y printing.
● File error
This error occurs when file recording cannot be made due to internal HDD free space shortage
or other causes. After reducing data in the internal HDD, execute recording. Even a file error
occurs, the X-Y printing continues.
12-6
RA2300A Recorder (7001754-R01)