Rear Brake Wear Inspection - Triumph Trident Owner's Handbook Manual

MAINTENANCE
116
2
chbe_2
1. Carrier plate
2. Brake pad lining
Brake pads for this model supplied by
Triumph will have the carrier plate at
the recommended thickness. Always
have replacement brake pads supplied
and installed by your Triumph dealer.
If the lining thickness of any brake pad
is less than that specified in the table,
replace all the brake pads on the wheel.
Minimum Brake Pad Lining
Thickness
Minimum Carrier Plate Thickness
Minimum Service Thickness
(Brake Pad Lining and Carrier
Plate)
1
0.06 in (1.5
mm)
0.16 in (4.0
mm)
0.22 in (5.5
mm)

Rear Brake Wear Inspection

Warning
If installing new proprietary brand
brake pads, check that the brake
backing plate of the brake pad is the
specified thickness shown in the table.
Installing brake pads with the brake
backing plate less than the specified
thickness may result in brake failure
due to the possible loss of the brake
pad as it wears.
1
1. Carrier plate
2. Brake pad lining
Brake pads supplied by Triumph will
have the carrier
recommended thickness. Always have
replacement brake pads supplied and
installed by your Triumph dealer.
If the lining thickness of any brake pad
is less than that specified in the table,
replace all the brake pads on the wheel.
Minimum Brake Pad Lining
Thickness
Minimum Carrier Plate Thickness
Minimum Service Thickness
(Brake Pad Lining and Carrier
Plate)
2
plate at the
0.06 in (1.5
mm)
0.12 in (3.0
mm)
0.18 in (4.5
mm)