Installation Instructions - HAMPTON BAY 281-585 Instruction Manual

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1ea Lock Nut (#2)
1ea Ground Screw (#10)

INSTALLATION INSTRUCTIONS:

1. Screw the Nipple (#13) into the Mounting Strap (#9). Tighten the Hex Nut (#12) against
the Mounting Strap (#9) to secure the Nipple (#13). Attach the Mounting Strap (#9) to
the Outlet Box (#7) using the two Outlet Box Screws (#11). [Make sure the longer end of
the Nipple (#13) is facing outside when the Mounting Strap (#9) is attached to the Outlet
Box (#7).]
2. Wrap the ground wire from the fixture around the Ground Screw (#10) on the Mounting
Strap (#9), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#7). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#7). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#7). Cover the three connections using the three Wire
Connectors (#8). Wrap the three wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#7). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the Wall Plate (#1) over the Nipple (#13) all the way to the wall. Screw the Lock
Nut (#2) onto the Nipple (#13) until the fixture body is held firmly against the wall.
4. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#1) to prevent water seeping into the Outlet Box (#7). Leave
the bottom 1/4 area uncaulked for drainage of any water which might leak into the
enclosure.
5. Before completing Installation, please return to Assembly Instruction #3.
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light on to activate the fixture.
Page 6
3ea Wire Connectors (#8)
2ea Outlet Box Screws (#11)
1ea Mounting Strap (#9)
1ea Hex Nut (#12) 1ea Nipple (#13)