Installation Instructions - HAMPTON BAY Home Depot 756-001 Instruction Manual

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1ea Ground Screw (#9)
1ea Cross Bar (#6)

INSTALLATION INSTRUCTIONS:

1. For optimal motion sensing, mount the fixture on your
wall at a height of more than 6 feet from the ground, and
the front of the fixture should be parallel to the direction
of expected movement (see picture A), instead of
perpendicular to the direction of expected movement
(see picture B).
2. Screw the two Mounting Screws (#8) into the Cross Bar (#6). Mount the Cross Bar (#6)
to the Outlet Box (#4) using the two Outlet Box Screws (#7). [Make sure the threads of
the Mounting Screws (#8) are facing outside when the Cross Bar (#6) is attached to the
Outlet Box (#4).]
3. Wrap the ground wire from the fixture around the Ground Screw (#9) on the Cross Bar
(#6), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#4). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#4). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#4). Cover the connections using the Wire Connectors (#5).
Wrap the wire connections with electrical tape for a more secure connection. Position the
wires back inside the Outlet Box (#4). Note: If you have electrical questions, consult your
local electrical code for approved grounding methods.
4. Place the fixture body on the wall by aligning the protruding Mounting Screws (#8) all
the way through the Wall Plate (#1). Tighten the fixture to the wall by screwing the two
Lock Nuts (#2) onto the two protruding Mounting Screws (#8).
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture. (See Page 4 for PIR motion sensor instructions.)
Page 6
2ea Outlet Box Screws (#7)
2ea Lock Nuts (#2)
2ea Mounting Screws (#8)
3ea Wire Connectors (#5)