Assembly And Installation - HAMPTON BAY PNB000003-03 Use And Care Manual

Assembly and Installation

Installing the fixture with the wire routed behind the
3
mounting surface
NOTE: This document provides two different methods for routing
the lead wire. You can choose which method best fits your needs.
Place the cardboard template (G) on the mounting surface and mark
□
where the holes should be for the male plug (B) and the self-threading
screws (E).
Use at least a 7/16 in. drill bit to drill a hole on the surface large
□
enough
Insert the male plug (B) through the hole on the mounting surface.
□
Insert the male plug (B) into the female plug (D).
□
Place the d eck lights (A) against the mounting surface.
□
Use a Phillips screwdriver to screw the self-threading screws (E)
□
through the two holes on the d eck lights (A) to secure the d eck lights (A)
to the mounting surface.
Installing the fixture with the wire in front of
4
the mounting surface
Place the cardboard template (G) on the mounting surface and
□
Mark where the holes should be for the self-threading screws
□
(E).
Insert the male plug (B) into the female plug (D).
□
The wire plugs may be retained inside the back of the d eck
□
(A) by coiling the wire and plugs and dropping the wire
lights
through the notch in the bottom of the d eck lights (A).
The wire plugs may be left outside the d eck lights (A) by
□
dropping the wire through the notch in the bottom of the d eck
(A) with the plugs outside the back plate when the fixture
lights
is mounted. The connected plugs are waterproof.
Place the d eck lights (A) against the mounting surface.
□
Use a Phillips screwdriver to screw the self-threading screws
□
(E) through the two holes on the d eck lights (A) to secure the
d eck lights (A) to the mounting surface.
2