Table of Contents
Advertisement
Calling up status messages
Status messages can be called up for the following
areas, subject to the system equipment level:
■
Actual/balance values
■
Cascade
■
DHW
DHW circulation
■
Pasteurisation
■
Return stratification
■
■
Fault relay
■
Messages
■
Service
"Status"
"Cascade"
"Act. / balance val."
"DHW"
DHW avail.
TDHW set modulat.
T DHW set
"DHW circ."
DHW circulation
"Pasteurisatn"
Pasteurisation
Pasteu. dur.
"RT stratif."
RT stratification
"Fault relay"
Fault relay
"Messages"
"Service"
S1 to S8
VFS T
VFS dV
PWM1/PWM2
R1 to R3
R_pot.free
Scanning temperatures and operating conditions
Press the following keys:
1. OK
to confirm for "Status".
Press the following keys:
1. OK to confirm for "Status"
2.
3. OK to confirm.
4.
Explanation
Different status information about the cascade is displayed, depending on the
system configuration.
For calling up temperatures and operating conditions, see page 29.
DHW heating status
Only shown if this function is set.
DHW temperature
Shows whether DHW circulation is enabled or disabled.
Shows whether pasteurisation is enabled or disabled.
Duration of active pasteurisation
Shows whether return stratification is enabled or disabled.
Shows whether the potential-free fault relay is enabled or disabled.
The display of status, fault and warning messages depends on the system
equipment level; see also page 31.
Displays the temperature captured at the sensor shown.
Displays the temperature captured at the combined temperature/flow sensor.
Displays the flow rate captured.
Displays which circulation pump is controlled with the PWM signal shown.
Displays what is switched with the relay shown.
Displays what is connected to the potential-free relay.
2. OK
3.
Service settings and scans
to call up the required value.
to display further messages (see table below).
to confirm for "Act. / balance val.".
/
Subject to system configuration, values from
the following table can be scanned.
29
Advertisement
Table of Contents
