Table of Contents
Advertisement
Central heating
Required settings
If you require central heating, check the following
points:
Have you selected the heating circuit?
■
For information on settings, see chapter "Selecting a
heating circuit" on page 24.
■
Have you set the required room temperature?
For settings, see page 24.
Selecting a heating circuit
The heating of your rooms can be split over several
heating circuits if necessary.
In the case of heating systems with several heating
■
circuits, for all central heating settings, first select the
heating circuit for which you want to make a change.
■
This selection is not available in heating systems
with only one heating circuit.
Heating circuit 1
Ù
Set room temp
Operating program
Party mode
Economy mode
Select with
Fig. 20
The heating circuits are marked at the factory as
"Heating circuit 1" (HC1), "Heating circuit 2" (HC2)
and "Heating circuit 3" (HC3, if installed).
Setting the room temperature
You can set the standard room temperature (for day,
see page 24) and the reduced room temperature (for
night, see page 24) for the relevant heating circuit.
Setting the standard room temperature for stand-
ard heating mode
Press the following keys in the standard menu:
1.
/
to select "Heating".
|
~
2.
to confirm.
d
3.
/
to select "Heating circuit 1" (HC1), "Heat-
Ù
Ú
ing circuit 2" (HC2) or "Heating circuit 3"
(HC3, if installed).
4.
/
for "Set room temp".
|
~
5.
to confirm.
d
24
HC1
HC1
Heating circuit selection
Ú
21°C
Ú
Was selected
(
■
Have you set the correct operating program?
For settings, see page 25.
Have you set the required time program?
■
For settings, see page 25.
Example:
■
"Heating circuit 1" is the heating circuit for the
rooms occupied by you.
"Heating circuit 2" is the heating circuit for the
■
rooms of a separate apartment.
HC2
HC2
Ù
Ú
Heating circuit 2
If you or your heating contractor have renamed the
heating circuits (as "Apartment" for example), this
name is displayed instead of "Heating circuit 1" (see
page 36).
6.
/
for the required temperature.
|
~
7.
to confirm.
d
"Adopted" appears briefly in the dialogue
line of the display.
8.
until the default display is shown.
ä
Set the room temperature for reduced heating
mode (night setback)
Heating circuit 1
Set room temp.
Set red. room temp.
Heating program
Party mode
Select with
Fig. 21
HC1
Advertisement
Table of Contents
