Programming Mode - Deckma Hamburg OMD-2005 Instruction Manual

10.4 Programming Mode

In the programming mode the alarm set points, the time delays, the signal output
and the zero can be modified. It is also possible to recall the factory default
OK
After start the display will show
the initial display followed by
the actual measured oil content.
This display also be shown, if
no input at the different menu's
has been done for a designated
time
To get into the menu press the
tool button. Select the required
point by using the „+" or „-„
button. Press the „OK" button.
Issue: 27.05.08
DECKMA HAMBURG GmbH
values at any time. The clock is
factory set for GMT, Greenwich Mean
Time, and cannot be changed.
There are 8 push buttons to control
the functions of the display. In general
are the upper buttons for the data
logger and the lower buttons for
changing the display to the different
pages of the menu.
Pressing the OK button will give
more detailed information about
the status
At the service menu the alarms,
time delays, the Offset and the
output signal can be modified
within the limitations. Select the
required point by using the „+"
or „-„ button. Press the „OK"
button.
Instruction Manual OMD-2005
To change the value, press
the "+" or "-" button. Confirm
with "OK".
Page 15 of 25