Safety Instructions - Wallbox Pulsar Installation Manual

Safety Instructions

• Do not operate if physical defects such as cracking, breakage, corrosion, or other damage are observed.
In this case, please contact your distributor.
• Only an authorized specialist and qualified personnel may open, disassemble, repair, alter or modify the
Wallbox device. Unauthorized modification of the Wallbox equipment makes manufacturer warranty
void.
• Unauthorized modifications or conversions are not allowed.
• Do not delete any warning on the device, such as safety symbols, warning notices, rating plates,
identification plates or cable markings
• Protect your Wallbox device from any impact which it may be exposed.
• The charging station does not have its own power switch. Always respect local electricity rules and
regulations, as relevant.
• Wallbox chargers can only be used under the operating parameters specified and within the normal
ambient conditions described in the Product Description.
• Do not use your Wallbox charger under adverse climatic conditions that could affect the vehicle or the
Wallbox device. Do not open the cover in the rain.
CONNECTOR RECOMMENDATIONS
• Always check the charging cable and the contacts for damage and contamination before use.
• Never use a damaged charging cable, the vehicle plug, or the infrastructure electrical outlet to charge.
• Never use contacts that are dirty or wet.
• Only connect the connector to vehicle plug and infrastructure electrical outlets that are protected
against water, moisture and liquids.
• After stopping the charging process, the vehicle connector and the equipment plug can be
disconnected. Never use force to disconnect the vehicle connector from the inlet or the equipment plug
power outlet. Such dangerous activity can cause serious injuries or even death.
• Depending on the charging station and the electric vehicle, the time to complete the charging process
and the duration of unlocking may vary.
• Some vehicles can be started with the charging cable connected. Be sure to unplug before driving off.
• Do not use the charging cable with an extension cable or an adapter.
• If the connector emits smoke or begins to melt, never touch the charging cable. If possible, stop the
charging process. In any event, disconnect the power supply from the Wallbox device.
• Keep the charging cable out of the reach of children.
• Be careful with the connector, do not step on it or on the cable.
• The cable should NOT be tightened under ANY CIRCUMSTANCES while connected to the vehicle.
Important information for the correct disposal of the product in accordance with Directive 2012/19/EC. At the
end of its useful life, the product will not be disposed of as urban waste.
It must be taken to a collection center for special and differentiated waste or to a distributor that provides this
service.
en 3