Mixer; Delay Time - Datavideo AD-300 Instruction Manual


Rotate the MENU SETTING knob to switch between 6 and 12 dB then press the
knob to select.

Select ESCAPE to exit and return to the VOLUME sub menu.

Mixer

AD-300 can also be used as a mixer which combines one or more input channels into a
single output channel. You can mix different combinations of input channels onto the
output channels L and R. Follow the steps outlined below to set the mixer:

Press the MENU SETTING knob to access the system configuration menu.

Rotate the MENU SETTING knob to MIXER then press the MENU SETTING knob
again to access the MIXER sub menu.

There are two mixers, one for audio out L and one for audio out R.

Select a mixer then set the mixing combination by enabling an input channel or
the test tone in the squares. The available options are listed in the order as
follows:
-
L = RCA-L
-
R = RCA-R
-
1 = XLR-1
-
2 = XLR-2
-
3 = XLR-3
-
T = Test tone
Note: An empty square () indicates that the input channel is disabled.

Once done, select ESCAPE to exit and return to main menu.

Delay Time

Delay Time sets the delay time of the input channels listed as follows:

RCA-L/CH 1

RCA-R/CH 2

XLR-1/CH 3

XLR-2/CH 4

XLR-3/CH 5
Follow the steps outlined below to adjust the delay of a particular input channel:

Press the MENU SETTING knob to access the system configuration menu.

Rotate the MENU SETTING knob to DELAY TIME.
18