NordicTrack T 8.0 User Manual page 8

3. Identify the Right Upright (82), which is marked
with a "Right" sticker.
Hold the Right Upright (82) near the Base (92)
as shown.
See the inset drawing. Tie the wire tie in the
Right Upright (82) securely around the end of
the Upright Wire (85). Then, pull the other end
of the wire tie until the Upright Wire is routed
through the Right Upright.
4. Hold the Right Upright (82) against the Base
(92). Be careful not to pinch the Upright
Wire (85). Insert two 3/8" x 4 1/4" Screws (6)
with two 3/8" Star Washers (10) and a 3/8" x 1
1/2" Screw (7) with a 3/8" Star Washer (10) into
the Right Upright.
Partially tighten the 3/8" x 4 1/4" Screws (6) until
the heads of the Screws touch the Right Upright
(82); do not fully tighten the Screws yet.
Next, partially tighten the 3/8" x 1 1/2" Screw
(7).
3
85
Wire Tie
82
Wire
Tie
85
4
82
8
82
6
7
10
10
85
92
85
92