NordicTrack T 8.0 User Manual page 11

9. Pivot the top of the Console (98) in the direction
shown, and insert the console wire through the
indicated hole in the Console Base (101) and
through the indicated plastic tie.
Next, insert the ground wires into the Console
(98) as you hold the Console against the
Console Base (101). Set the Console face down
on a soft surface to avoid scratching the
Console.
Attach the Console (98) to the Console Base
(101) with four #8 x 3/4" Screws (1); start all
four Screws, and then tighten them. Be care-
ful not to pinch any wires.
10. Set the console assembly on the edge of a
table, a chair, or something similar. Tip: Place
something soft on the surface to avoid
scratching the console assembly.
Identify the Right Handrail (77).
Hold the Right Handrail (77) near the console
assembly. Tie the wire tie in the Right Handrail
securely around the end of the console wire.
Then, pull the other end of the wire tie until the
console wire is routed through the Right
Handrail as shown.
11. Align the bolt holes in the Right Handrail (77)
with the holes in the ends of the Handrail
Crossbars (74); rotate the Handrail Crossbars
slightly, if necessary.
Make sure that the wires under the Wire
Cover Plate (109) are not pinched.
9
Ground
Wires
Hole
Console
Wire
10
Console
Wire
Wire
Tie
11
77
11
98
101
1
Plastic
Tie
Hole
Assembly
77
Bolt
Holes
74
1
Console
109