Maintenance - iFIT WEIDERBLACK WBBE14908.0 User Manual

ADDING WEIGHTS TO THE BARBELL OR THE
WEIGHT CARRIAGE
To use the Weight Bar (18) or the Weight Carriage
(7), slide the desired amount of weight (not included)
onto the Weight Bar Adapters (22) or the Weight
Carriage Tubes (8). Secure the weights with the
Spring Collars (27).
WARNING:
than 310 lbs. (141 kg) on the Weight Bar (18),
or 150 lbs. (68 kg) on the Weight Carriage (7).
Always place the same amount of weight on
each side of the Weight Bar or the Weight
Carriage. Always secure weights with the
Spring Collars (27). Always lower the weight
carriage and the weight bar in a controlled
manner; never let the weight carriage or the
weight bar drop.

MAINTENANCE

Make sure that all parts are properly tightened each time the weight bench is used. Replace any worn parts
immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not
use solvents to clean the weight bench.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight bench, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. First, add weights to the weight car-
riage (see ADDING WEIGHTS TO THE BARBELL OR THE WEIGHT CARRIAGE above).
Remove the M10 Locknut (65) and the M10 x 45mm
Bolt (69) from the Small Pulley (33) near the lower
end of the two Pulley Plates (56). Reattach the Small
Pulley to the hole closer to the center of the Pulley
Plates. Make sure that the Low Cable (52) and the
Small Pulley move smoothly.
If necessary, adjust the position of the Small Pulley
(33) near the upper end of the Pulley Plates (56) in
the same way.
Do not overtighten the cables. If a cable tends to slip off the pulleys often, it may have become twisted.
Remove the cable and reinstall it. If a cable needs to be replaced, see the back cover of this manual.
All manuals and user guides at all-guides.com
Do not place more
18
18
7
8
Weight
Weight
22
27
33
56
69
65
33
52
27